ASTA TOOLS LIMITED COMPANY

Specjalized Tools For Motorcycles

  • A-MK425

    V-TWIN BEVEL DRIVE EXHAUST NUT WRENCH   This specialized wrench is purpose designed to protect the nuts on your Ducati from being scratched. It fits Ducati bevel drive twins and single exhaust nuts

  • A-MK422

    CLUTCH HUB AND DRUM TOOL   It is designed to hold both clutch basket and hub while removing both of these items. It allows you to assemble the R&R clutch in safety, especially if you are installing an aftermarket clutch basket.

  • A-MK421

    Alternator Cover Puller   It is essential tool to remove the left hand side cover on Ducati Engines. Puller provides one tool body (made from 6061 aluminum) and comes with 3 bolts (M10x1.25x50L 1 pc. M6x1.0x30L 2pc).

  • A-MK391

    MOTORCYCLE VALVE ADJUSTMENT KIT FOR TRIUMPH   It makes the valve adjusting easier. Fits most Triumph 500/650/750 twins 1950’s-1970’s Fits 7/16 SAE, British 1/4 BS, 3/16 W, 5/16 BS, 1/4 W

  • A-MK384

    TIMING AND CRANKSHAFT TURNING TOOL FOR DUCATI   Ideal tool to turn timing mark on the degree wheel for perfect valve adjustments. It makes ignition-timing work to be performed. Works on most (1990 – present) 750cc, 900cc and 916cc street bike models.

  • A-MK852

    9-PIECE STUD REMOVAL & INSTALLATION TOOL SET     This tool set provides various sizes for stud installation. Sizes as the following: 7/16

  • A-MK830

    ALTERNATOR REMOVAL TOOL   Fits most big twin with Bosch alternator mounted at the front of the crankshaft. Use to remove retaining bolt, screw in tool until snug, rap head with mallet, rotor should pop off from taper.

  • A-MK819

    SHAFT HOLDING TOOL SET   There are magnets on the tool to prevent falling while service. Size : 14, 16, 18, 32, 35, 10, 12, 12.5, 14, 20, 24, 29 mm and 1/2

  • A-MK812

    CARBURETOR FLOAT HEIGHT TOOL   Screwed into the bottom of the float bowl on through the drain plug hole. with the petrol tap switch on and the pipe next to the carb the actual level of the fuel can be seen in the float. It fits Mikuni VM Carburetor 22/24/26/28mm.

  • A-MK793

    BEARING DRIVER SET Set fits bearing with 8-30 mm I.D. and 32-47 mm O.D. Set provides one durable steel handle and 12 sizes of anodized aluminum adapters : 8mm, 10mm, 12mm, 15mm, 17mm, 20mm, 25mm, 30mm, 32mm, 35mm, 40mm and 47mm. Set can be used with a hammer or shop press.