SATRA
-
S-TA4JP
4PCS LIFTING JACK PADS SET FOR TESLA MODEL 3 & Y & S & X This pad tool is specially made to work with the Tesla vehicle chassis. There are specific jack points for the Tesla vehicle. Without an appropriate pad tool, it may be risked to damage the battery of the vehicle when […]
-
S-EC110M
EXPANDABLE/ COLLAPSIBLE MAGNETIC PARTS TRAY Made of oil-resistant ABS + Silicone with five small strong locating magnets, attaches to any ferrous surface. Ideal for storing nuts, bolts, screws, washers and sockets during disassembly/assembly. Suitable for dismantlers, recovery vehicles and engine re-builders. Lays flat for easy storag Open Dimensions: (W x D x H): 110 […]
-
S-90036
CLUTCH RETAINING BOLT 6- SPEED GEARBOX FOR VAG 02E
-
S-THOR7500ELPG
7.5KW GASOLINE LPG GENERATOR Model S-THOR7500ELPG Type 7.5KW Gasoline/GAS Generator Rated Frequency (Hz) 50Hz Rated Voltage (AC) 230V / 400V Voltage system Condenser compensation system Excitation Self-excitation voltage Rated Output Power (KW) 7.0 Max Output Power (KW) 7.5 Power Factor 1.0 DC Rated output (V-A) 12-8.3 Bore X Stroke (mm) 92×66 Speed (rpm) 3000 Overload Protect […]
-
S-90206
TRANSSMISION AND OIL DIPSTICK MERCEDES-BENZ Red: 1,220 mm long for gearbox oil Green: 920 mm long for gearbox oil Blue / Yellow:930 mm long for engine oil
-
S-90189
STAINLESS STEEL DRAIN TRAY 600X400X50MM
-
S-IDSP
Diesel Injector Seal Puller Tip diameter: min 4.5mm to max 13.2mm Features: Easy to remove seal. No moving parts to drop into the engine. The tapered threaded end of the tool is screwed into the copper seal to clamp, then tapped firmly with the built-in slide hammer.
-
S-14HS3
3pcs SCREWDRIVER SOCKET ADAPTER SET 1/4″ HEX TO 1/4″, 3/8″, 1/2″ Dr. Material: CR-V 1/4″ Hex to 1/4″ Dr. (Length: 65mm) 1/4″ Hex to 3/8″ Dr. (Length: 65mm) 1/4″ Hex to 1/2″ Dr. (Length: 70mm) Socket wrench locking mechanism. Allow to mount 1/4″, 3/8″ or 1/2″ Dr. socket on a screwdriver or a 1/4″ […]
-
S-90178
3pcs FLEXIBLE HONING BRUSH SET Specification: . Contents: 8mm x 80grit, 12mm x 60grit, 20mm x 60grit with 1/4″ Dr Quick Change Shank . Material: Silicon Carbide . Total Length: 150mm . Recommended Speed : 300-700rpm Features: Use with hand drills. Recommend to use with honing / grinding oil. Different abrasive types meet various […]
-
S-90061
PUMP FOR DRILL Specification: Drive shaft: 8mm Capacity: Max. 2.4mm3/h Hose connection: 3/4″(19mm) Pressure: Max. 3BAR Delivery height: Max. 30M Suction height: Max. 3M Temperature of the fluid being pumped: Max. 40°C Dry run time: Max. 12 seconds Rotation speed: Max. 3400RPM Features: Connect to all standard drills. Simple attachment to pump water by using […]